• Non splatter-non drying formula
• Spearmint flavored
• With potassium nitrate topical desensitizer

Platina Hi-Gloss is an aluminum oxide paste for the final polishing of direct or indirect anterior and posterior resin restorative materials. It contains potassium nitrate topical desensitizer for patient comfort.

Platina Hi-Gloss Composite Polishing Paste is water-soluble, aluminum oxide paste designed for final polishing of anterior and posterior composite restorations and veneers. Platina Hi-Gloss improves the smoothness of the finished surface of microfilm composites to a final, high luster surface, or pre-polishes by smoothing finished surfaces of hybrid and micro-hybrid composites to low luster. For hybrid and micro-hybrid composites, following with Platina Hi-Gloss Polishing Paste results in a final, high luster polished surface.

Indications :

• Final polishing of direct and indirect composite restorations / veneers

Techincal Data :

• Consistency : 29 mm
  
• Film Thickness : 60 µm

Composition :

• Glycerin
• White Fused Alumina
• Polyethylene Glycol
• Amorphous Silica
• Spearmint Oil

Storage Conditions :

• Store at temperature between 10°C to 24°C.
• Close the cap carefully after use.
• Keep away from moisture.
• Shelf life not affected after opening if stored in a cool dry place.

Shelf Life : 3Years from the date of manufacturing.

• 1 x Syringe 4gm

1. Place composite restoration as per standard techniques. Complete gross reduction
of excess and general outline form of the restoration using carbide finishing burs or
diamond finishing instruments. Additional finishing and polishing is obtained by use of
Enhance Discs, Cups or points. Alternatively, other standard aluminum oxide disc
series may be used (see complete directions of finishing instruments). Prior to
proceeding to polishing with Platina Hi-Gloss Composite Polishing Pastes, the
restoration should be finished to a final contour. Surface should be smooth and defect
free.

2. Attach a enhance Foam Polishing Cup to the provided mandrel by inserting the
bayonet end of the mandrel into the opening on the narrow end of the cup. Rotating the
mandrel ¼ turn makes insertion easier. Make sure the mandrel inserts fully into the
cup. Insert the mandrel into a conventional speed contra-angled hand piece.

3. Dispense a portion of Platina Hi-Gloss Polishing Paste onto a clean paper pad or
dappen dish. Recap syringe promptly.

4. Apply a small amount of Platina Hi-Gloss Polishing Paste to the surface of the
enhance Cup. Without running the hand piece apply material to the surface to be
polished. Running slowly at first, using overlapping, continuous circular motions, work
the surface of the restoration, dry initially, up to moderate speed and pressure, use flat
end and corner edge of cup.

5. To increase surface luster, add water in small amounts (i.e drop wise) to dilute the
paste using a light circular buffing action. Repeat as needed to produce a smooth
surface.

6. Rinse Platina Hi-Gloss from the tooth surface and enhance Cup. This is the final
step for microfilled composites. Continue with the next step for hybrid and microhybrid composite materials.

7. Dispense and apply Platina Hi-Gloss Extra Fine Paste to the Enhance Cup as
described in steps 3 and 4 and polish the surfaces dry at first, then adding increasing
amounts of water for 15-30 seconds at higher speed, with a lighter buffing pressure for
final luster. The Enhance Cup should be discarded after use.

8. Clean excess material from oral surfaces with air/water spray and/ or instruct patient
to rinse and expectorate.